Stainless Steel Kennels All partitions of kennels shall either be anchored securely to the facility floor and where feasible, anchored to existing room walls or shall be free standing requiring no tabs for wall or floor anchors (only if supplied with back panels).
Side Panels The lower 48" of the panels shall be solid construction and the upper portion shall be rod construction.  Basic framing member shall be 1 1/4" square 18 gauge stainless steel tube type 304 with P-180 polished finish.
Swing Gate The gates shall be framed with 1 1/4" square 18 gauge stainless steel tube 304 alloy with a P-180 polished finish.
Back Panels Basic framing member shall be 1 1/4" square, 18 gauge stainless steel tube with P-180 polished finish.
Roof Panels Roof panels shall be framed with 1 1/4" square 18 gauge stainless steel with P-180 finish tube.
Floorings Flooring shall be of 9 gauge expanded metal and braced every 16" with 3/8" x 1" flat bar turned on its edge.  After fabrication the entire floor shall be coated approximately 1/8" thick with a chemically treated vinyl.  The vinyl acts as a soft, easy-to-clean surface while the chemical retards growth of bacteria and fungi.
Resting Bench Basic framing member shall be 1" square, 18 gauge stainless steel tube with P-180 polished finish.
Feeders Feeders shall have a hinged lid and be fabricated of 20 gauge stainless steel type 304-2B and have a capacity of at least 10 lbs.

[ Home ] [ Up ]